03

23-01

Two ways to use ISE probe ion selective electrodes

2023-01-03

The ISE probe ion selective electrode analysis method is a quantitative analysis method based on the measurement of the electromotive force of the battery.

19

22-12

Typical Structure of a Multiparameter Analyzer

2022-12-19

Among them, r1, r2, l1, n1, n2 respectively represent the temperature value and humidity range of the channel and the input impedance of the voltage output terminal;

05

22-12

Care and Maintenance of ISE Probes

2022-12-05

There are three main precautions you can take to ensure long life and accurate measurements: keep the ISE filled with electrolyte fill solution, store the electrodes properly, and replace the membrane when needed.

21

22-11

pH/ion meter operation steps

2022-11-21

After pressing the measurement key of the instrument, clean the electrode with deionized water, and wait for the instrument potential value to display above 340mv, then start to measure the sample liquid.

18

22-11

Precautions for using automatic potentiometric titrator

2022-11-18

Depending on the frequency of use, titrator equipment such as burettes, pistons, valves, and pipelines should be cleaned more frequently. Always use high-quality ethanol for cleaning.

16

22-11

Instrument characteristics of automatic potentiometric titrator

2022-11-16

During the titration process, the acquisition signal is 0.1 mV, and the minimum titration feed can reach 0.0025 ml, which is about 10 times higher than that of other common titrators.

< 12 >